AirLive WN-200R User Manual download pdf (Page 84)

AirLive WN-200R User’s Manual

Chapter 8 : Access Point Mode

This Chapter explains configuration and operation when in "Access Point".

8.1 Overview

There are two modes available on the Access Point screen.

• Router - In this mode, this device can provide shared Internet Access to all your LAN users. Also, by default, it

acts a DHCP Server, providing an IP address and related information to all Wireless and LAN users.

• Access Point - The device links your Wireless Stations to your wired LAN. The Wireless stations and devices on

the wired LAN are then on the same network, and can communicate with each other without regard for whether

they are connected to the network via a Wireless or wired connection.

This Chapter describes operation while in Access Point Mode.

8.2 Management Connections

• You need to have a DHCP Server on your LAN to provide IP addresses to the Wireless clients using this Access

Point.

• This AP must be a valid device on your LAN, to allow management connections. You must assign a (fixed) IP

address which is within the address range used on your LAN, but not within the address range used by your

DHCP server.

When you connect in future, just connect normally, using the IP address you assigned.

1. Start your WEB browser.

2. In the Address box, enter "HTTP://" and the current IP Address of the Wireless ADSL Modem, as in this example,

which uses the Wireless ADSL Modem's default IP Address:

HTTP://192.168.1.254

3. When prompted for the User name and Password, enter admin for the user name, and the current password, as

set on the password screen. (The password is the same regardless of the mode.)

8.3 Home Screen

If in Modem mode, the home screen will look like the example below.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 94 95

No comments

AirLive WN-200R User Manual Page 84