AirLive A.DUO User Manual Page 49
- Page / 191
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
4. Wireless and WAN Settings
AirLive A.DUO User’s Manual
42
Super-A with Static Turbo: Turbo mode uses channel binding technology to increase
the speed further over Super-A mode. This mode might not be allowed in countries that
prohibit channel binding (i.e. some EU countries). This mode will always turn on the
turbo mode in all conditions
Super-A with Dynamic Turbo: Dynamic Turbo mode will be turn on only when
adjacent channel is not used. It is also know as intelligent turbo mode. This mode
might not be allowed in countries that prohibit channel binding (i.e. some EU countries).
In addition, this mode does not work in WDS Bridge mode.
4.2.6 SuperA Option *Super Channel is NOT available in EU countries
Operation Mode -> Setup -> SuperA Option
When you select Radio Mode with “Super-A”, the SuperA Options will be available.
Bursting: Allow more data frame to be sent over given period of time by overhead
reduction.
Compression: Increasing throughput by compressing data frame in real time
Fast Frame: Utilizing frame aggregation and removing interframe pauses to increase
the throughput.
It is recommended to select all 3 options except for compatibility reasons with remote AP.
4.2.7 Channel
Operation Mode -> Setup -> Channel
The channel is the frequency range used by radio. In 802.11a standard, each channel
occupies 20MHz width. For 2 wireless devices to connect, they must use the same channel.
The number of available legal channels might be different between countries. For example,
Channel 149 to 161 are available only to United States and a few other countries. If you are
living outside EU, please change the country from the “Regulatory Domain” option in this
page. Below is the table list of channels and frequency.
- ’s Manual 1
- Copyright & Disclaimer 2
- Copyright and Disclaimer 3
- IMPORTANT NOTE 4
- Table of Contents 5
- Introduction 8
- 1.3 Wireless Operation Modes 9
- 1.5.1 Dual Band Router Mode 10
- 1.5.2 Dual AP Mode 11
- 1.5.3 WISP + AP Mode 12
- 1.5.4 Bridge + AP Mode 12
- 1.5.5 Dual Bridge Mode 13
- 1.5.6 Client + AP Mode 14
- 1.5.7 Bridge + Gateway 15
- 1. Introduction 16
- Installing the A.DUO 17
- 2.3 Knowing Your A.DUO 18
- 2.4 Installation steps 20
- 2. Installing the A.DUO 21
- Configuring the 25
- 3.2 Prepare Your PC 26
- 3.3 Management Interface 27
- 3. Configuring the A.DUO 28
- 3.3.5 SNMP Management: 32
- 3.5 Initial Configuration 37
- 3.5.6 Change Password 41
- Wireless and WAN 42
- Settings 42
- 4.2.1 Regulatory Domain 46
- 4.2.2 Network SSID 46
- 4.2.3 Site Survey 46
- 4.2.4 Signal Survey 48
- 4.2.7 Channel 49
- 4.2.8 Channel Width 50
- 4.2.9 Security Settings 51
- 4.2.10 Distance 56
- 4.2.11 Advance Settings 57
- 4.2.12 Access Control (ACL) 60
- 4.2.13 Multiple SSID 61
- 4.2.14 WMM QoS Setting 67
- 4.2.15 RADIUS Settings 71
- 4.2.16 Bandwidth Control 72
- 4.3 AP Specific Settings 78
- 4.4.1 WDS Bridge Settings 82
- Local Area Network 84
- 4.6.1 WAN Port Settings 88
- 4.6.3 DHCP Server Settings 94
- 4.6.4 Multiple DMZ 95
- 4.6.6 Special Applications 97
- 4.6.7 IP Filtering Settings 98
- 4.6.8 IP Routing Settings 99
- 4. Wireless and WAN Settings 100
- AirLive A.DUO User’s Manual 100
- 4.6.9 Dynamic DNS Settings 101
- 4.7 WISP Specific Settings 103
- 4.7.1 WAN Port Settings 104
- 4.7.2 DHCP Server Settings 107
- 4.7.3 Multiple DMZ 108
- 4.7.5 Special Applications 110
- 4.7.6 IP Filtering Settings 111
- 4.7.7 IP Routing Settings 112
- 4.7.8 Dynamic DNS Settings 114
- Configuration 116
- 5. System Configuration 117
- 5.1.2 Time Settings 118
- 5.1.3 Password Settings 119
- 5.1.4 System Management 119
- 5. System Configuration 120
- 5.1.5 SNMP Settings 121
- 5.1.6 Ping Watchdog 123
- 5.1.7 Firmware Upgrade 125
- 5.1.9 Factory Default 127
- 5.1.10 Reboot System 127
- Device Status & Tools 130
- 6.1.2 Wireless Information 132
- 6.1.3 LAN Information 133
- 6.1.4 Internet Information 134
- 6.1.5 Wireless Client Table 135
- 6.1.6 System Log 136
- 6.1.7 Network Ping 137
- 6.1.8 Network Traceroute 138
- Command Line 139
- Interface 139
- 7.1 System Commands 140
- site survey 141
- 7.2 Debugging Commands 142
- 7. Command Line Interface 143
- 7.3 Show Commands 144
- show mac filter 145
- show mac filter mode 145
- show snmp 146
- show trap manager 146
- show radius server 146
- show log level 147
- show telnet / system 147
- show snmp statistics 148
- show rssi 148
- show mode 149
- show wireless setting 149
- show wireless security 149
- show antenna 150
- show ratemode 150
- show noise immunity 150
- 7.4 Set Commands 151
- erval <0~300> 158
- horizontal > 158
- arter> 158
- set security 158
- ver primary 162
- Questions 166
- Frequent Asked 166
- 8. Frequent Asked Questions 167
- Specifications 168
- Frequenc nnel 169
- Frequency Ran 169
- Frequency Band 169
- 9. Specifications 170
- Software 171
- Product Size (L x W x H mm) 172
- Glossary 173
- Wireless Network 173
Related products and manuals for Networking AirLive A.DUO
Networking AirLive A.DUO User Manual
(4 pages)
(4 pages)
Networking AirLive TRAVELER3GM User Manual
(200 pages)
(200 pages)
Networking AirLive WN250R User Manual
(160 pages)
(160 pages)
Networking AirLive WHB-5854A User Manual
(2 pages)
(2 pages)
Networking AirLive WL-5470AP User Manual
(9 pages)
(9 pages)
Networking AirLive WL-1500R User Manual
(11 pages)
(11 pages)
Networking AirLive NVR4 User Manual
(2 pages)
(2 pages)
Networking AirLive WN-200R User Manual
(2 pages)
(2 pages)
© 2020, manymanuals.com. All rights reserved. | 0.194 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals